Difficulty
Moderate
Steps
8
Time Required
20 minutes
Sections
1
- Motherboard
- 8 steps
Flags
0
BackLG Optimus T
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motherboard
- Working on your device while it is turned on may result in electric shock. Make sure to shut down and unplug your device before you begin.
- Using a prying device, such as a plastic opening tool, remove the phone’s back cover. At the top of the phone, there’s an indentation to put the Spudger into to pop the case off
Working on your device while it is turned on may result in electric shock. Make sure to shut down and unplug your device before you begin.
Using a prying device, such as a plastic opening tool, remove the phone’s back cover. At the top of the phone, there’s an indentation to put the Spudger into to pop the case off
1024
Step 2
- Remove the battery. There’s an indentation to the left of the camera lens to pull up on the battery with your finger
Remove the battery. There’s an indentation to the left of the camera lens to pull up on the battery with your finger
Step 3
- Use a J0 screwdriver to remove the six 4.5mm screws.
Use a J0 screwdriver to remove the six 4.5mm screws.
Step 4
- You might have difficulty popping the interior case off. You may use the metal spudger here with caution if the plastic opening tool fails
- Remove interior case. Insert the spudger into the indentations at the top, or bottom of the phone to pry off the interior case.
You might have difficulty popping the interior case off. You may use the metal spudger here with caution if the plastic opening tool fails
Remove interior case. Insert the spudger into the indentations at the top, or bottom of the phone to pry off the interior case.
Step 5
- Pull up on connector tab
Pull up on connector tab
Step 6
- Remove SD card mount. Insert the plastic opening tool on the right side to pop off
Remove SD card mount. Insert the plastic opening tool on the right side to pop off
Step 7
- Remove metal panel
- There are four retaining points to insert plastic opening tool and pop off panel
Remove metal panel
There are four retaining points to insert plastic opening tool and pop off panel
Step 8
- Use a J0 screwdriver to remove the two 1.8mm screws from charging port. (Charging port and motherboard are connected.)
- Remove motherboard
Use a J0 screwdriver to remove the two 1.8mm screws from charging port. (Charging port and motherboard are connected.)
Remove motherboard
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
stacey
Member since: 02/07/2017
219 Reputation
2 Guides authored
Badges:
5
+2 more badges
Team
Ohio State, Team 1-3, Wilder Spring 2017
Member of Ohio State, Team 1-3, Wilder Spring 2017
OSU-WILDER-S17S1G3
4 Members
5 Guides authored