Lg Optimus T Camera And Camera Mount Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          25 minutes            

Sections

1

• Camera
• 8 steps

Flags

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

• BackLG Optimus T

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Camera               

• Working on your device while it is turned on may result in electric shock. Make sure to shut down your device before you begin.
• Use a plastic opening tool to remove the phone’s back cover. At the top of the phone there are indentations to insert the spudger and pop the case off

Working on your device while it is turned on may result in electric shock. Make sure to shut down your device before you begin.

Use a plastic opening tool to remove the phone’s back cover. At the top of the phone there are indentations to insert the spudger and pop the case off

1024

Step 2

• Remove the battery by pulling up on the battery using the indentation to the left of the camera lens

Remove the battery by pulling up on the battery using the indentation to the left of the camera lens

Step 3

• Use a J0 screwdriver to remove the 6 highlighted screws

Use a J0 screwdriver to remove the 6 highlighted screws

Step 4

• Remove interior case using indentations on the top and bottom to insert the spudger to pop off the interior case
• You might have difficulty popping the interior case off. You may use the metal spudger here with caution if the plastic one fails

Remove interior case using indentations on the top and bottom to insert the spudger to pop off the interior case

You might have difficulty popping the interior case off. You may use the metal spudger here with caution if the plastic one fails

Step 5

• Unhook the connector tab

Unhook the connector tab

Step 6

• Remove SD card mount by inserting the plastic opening tool on the right side of the device to pop mount off

Remove SD card mount by inserting the plastic opening tool on the right side of the device to pop mount off

Step 7

• Remove metal panel by inserting plastic opening tool into the four retaining points and remove panel

Remove metal panel by inserting plastic opening tool into the four retaining points and remove panel

Step 8

• disconnect camera connector from motherboard by spudger
• Once disconnected, remove camera using tweezers

disconnect camera connector from motherboard by spudger

Once disconnected, remove camera using tweezers

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    stacey                     

Member since: 02/07/2017

219 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       Ohio State, Team 1-3, Wilder Spring 2017                        

                                                  Member of Ohio State, Team 1-3, Wilder Spring 2017 



                    OSU-WILDER-S17S1G3                     


                                            4 Members                     


                                            5 Guides authored