Lg Optimus L9 P769 Vga Front Facing Camera Replacement Repair Guide

Difficulty

Difficult

Steps

9

Time Required

                          25 minutes            

Sections

3

• Motherboard
• 4 steps
• Display Screen
• 4 steps
• VGA Front Facing Camera
• 1 step

Flags

0

• BackLG Optimus L9 P769

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Motherboard               

• Start by placing the device face down and remove the back cove.
• Remove the battery from the phone by lifting it using your finger or the prying tool

Start by placing the device face down and remove the back cove.

Remove the battery from the phone by lifting it using your finger or the prying tool

1024

Step 2

• Remove all 10 of the 4.5mm Phillips screws that holds the back frame to the case of the phone
• Using a small plastic prying tool, carefully remove the back frame by prying on the sides of the device.
• Do be careful when prying back frame and removing it as too much force may result in damaging the frame.

Remove all 10 of the 4.5mm Phillips screws that holds the back frame to the case of the phone

Using a small plastic prying tool, carefully remove the back frame by prying on the sides of the device.

Do be careful when prying back frame and removing it as too much force may result in damaging the frame.

Step 3

• Using tweezers, pinch the sides of the antenna node and pull straight up.
• Using a small prying tool, carefully remove the ribbon cables attached to the motherboard.

Using tweezers, pinch the sides of the antenna node and pull straight up.

Using a small prying tool, carefully remove the ribbon cables attached to the motherboard.

Step 4

• Using a spudger or small prying tool, lift up the motherboard from the chassis of the device.

Using a spudger or small prying tool, lift up the motherboard from the chassis of the device.

Step 5

              Display Screen               

• Using a spudger or small prying tool, pry off the latches that connects the digitizer to the chassis carefully.
• Do not force open as the latches attaching the digitizer to the chassis as they are easily damaged.

Using a spudger or small prying tool, pry off the latches that connects the digitizer to the chassis carefully.

Do not force open as the latches attaching the digitizer to the chassis as they are easily damaged.

Step 6

• Once the digitizer has been removed, turn the phone face down and remove the plastic housing for the front speaker. It should come off easily.

Once the digitizer has been removed, turn the phone face down and remove the plastic housing for the front speaker. It should come off easily.

Step 7

• Slide off the connector through the hole of the chassis slowly to avoid damaging it.

Slide off the connector through the hole of the chassis slowly to avoid damaging it.

Step 8

• Remove the primary or rear camera using a small opening tool to remove the adhesive and lift the camera up using a pair of tweezers.
• Using the same small opening tool, remove the connector that is taped to the chassis of the phone.
• Make sure that every bit of the connector is no longer sticking to the chassis of the phone.
• Similar to the digitizer, the connector should be able to slide through the hole of the chassis, completely detaching the LCD screen from the phone.

Remove the primary or rear camera using a small opening tool to remove the adhesive and lift the camera up using a pair of tweezers.

Using the same small opening tool, remove the connector that is taped to the chassis of the phone.

Make sure that every bit of the connector is no longer sticking to the chassis of the phone.

Similar to the digitizer, the connector should be able to slide through the hole of the chassis, completely detaching the LCD screen from the phone.

Step 9

              VGA Front Facing Camera               

• Once the screen has been removed, use a prying tool to lift off the front facing camera.

Once the screen has been removed, use a prying tool to lift off the front facing camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Blake Bennett                     

Member since: 03/01/2017

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       IUPUI, Team S2-G1, Harley Spring 2017                        

                                                  Member of IUPUI, Team S2-G1, Harley Spring 2017 



                    IUPUI-HARLEY-S17S2G1                     


                                            4 Members                     


                                            6 Guides authored