Difficulty
Moderate
Steps
7
Time Required
10 - 15 minutes
Sections
2
- Battery
- 2 steps
- Screen
- 5 steps
Flags
0
BackLG Optimus Dynamic II L39C
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Remove the back case
- Make sure not to push the tool into the USB port. Doing so may cause damage to your phone.
- Hold the blue plastic opening tool at the edge of the USB opening. Push down and pry the case off the phone gently.
Make sure not to push the tool into the USB port. Doing so may cause damage to your phone.
Hold the blue plastic opening tool at the edge of the USB opening. Push down and pry the case off the phone gently.
1024
Step 2
Remove the Battery
- Lift the battery out of the phone and replace with your new one.
Lift the battery out of the phone and replace with your new one.
Step 3
Remove the SD Card
- Grab the end of the SD Card and pull it out of the phone.
Grab the end of the SD Card and pull it out of the phone.
Step 4
Remove the screws from the midframe
- Use the PH #000 screwdriver to remove the six screws from the midframe
Use the PH #000 screwdriver to remove the six screws from the midframe
Step 5
Remove the midframe
- Using the plastic opening tool, work gently to go around the perimeter of the phone and remove the midframe.
Using the plastic opening tool, work gently to go around the perimeter of the phone and remove the midframe.
Step 6
Disconnect the screen from the motherboard
- Use the plastic opening tool to disconnect the small orange tab from the motherboard.
- Next disconnect the silver tab slightly above where the orange tab was.
Use the plastic opening tool to disconnect the small orange tab from the motherboard.
Next disconnect the silver tab slightly above where the orange tab was.
Step 7
Separate the screen and motherboard
- Gently feed the orange and silver tabbed ribbons through the hole in the motherboard and the screen will be free.
Gently feed the orange and silver tabbed ribbons through the hole in the motherboard and the screen will be free.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
6 other people completed this guide.
Author
with 3 other contributors
Patrick Barron
Member since: 10/08/2014
158 Reputation
1 Guide authored
Badges:
7
+4 more badges
Team
USF Tampa, Team 14-3, Leahy Fall 2014
Member of USF Tampa, Team 14-3, Leahy Fall 2014
USFT-LEAHY-F14S14G3
4 Members
3 Guides authored
Jack - Jul 24, 2017
Reply
My screen is black but everything else works (even the touch screen – I can use it to answer calls). I used this guide to change the screens from a working phone - but my screen is still black! Anyone have any ideas?