Difficulty
Moderate
Steps
6
Time Required
20 minutes
Sections
2
- Battery
- 3 steps
- Rear Phone Camera
- 3 steps
Flags
0
BackLG K7 T-Mobile
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Flip the LG K7 over so that the back of the phone is facing up.
- Locate the small notch on the bottom left side of the phone.
Flip the LG K7 over so that the back of the phone is facing up.
Locate the small notch on the bottom left side of the phone.
1024
Step 2
- Insert a plastic opening tool into the notch and lift the back cover upward while holding the bottom portion of the phone down to remove it.
Insert a plastic opening tool into the notch and lift the back cover upward while holding the bottom portion of the phone down to remove it.
Step 3
- Remove the battery.
Remove the battery.
Step 4
Rear Phone Camera
- Located to nine 3.4 mm screws that keep that keep the phones rear housing in tacked.
- Using a Phillips 00 screwdriver remove all nine 3.4 mm screws.
Located to nine 3.4 mm screws that keep that keep the phones rear housing in tacked.
Using a Phillips 00 screwdriver remove all nine 3.4 mm screws.
Step 5
- Turn the phone over so the screen is facing up
- Insert your plastic opening tool between the midframe and front panel assembly on the side of the phone.
- Slide the plastic opening tool down the seams carefully to separate the screen from the rest of the phone housing.
Turn the phone over so the screen is facing up
Insert your plastic opening tool between the midframe and front panel assembly on the side of the phone.
Slide the plastic opening tool down the seams carefully to separate the screen from the rest of the phone housing.
Step 6
- Locate the ribbon cable that holds the camera’s ribbon cable in place.
- Carefully remove the camera’s ribbon cable from the motherboard using the plastic removal tool.
- Holding the camera ribbon you just released pull upwards and the camera should release from the case.
Locate the ribbon cable that holds the camera’s ribbon cable in place.
Carefully remove the camera’s ribbon cable from the motherboard using the plastic removal tool.
Holding the camera ribbon you just released pull upwards and the camera should release from the case.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Salem Jean
Member since: 09/28/2017
204 Reputation
1 Guide authored
Badges:
9
+6 more badges
Team
USF Tampa, Team S2-G5, Nance Fall 2017
Member of USF Tampa, Team S2-G5, Nance Fall 2017
USFT-NANCE-F17S2G5
3 Members
8 Guides authored