Difficulty

Moderate

Steps

10

Time Required

Suggest a time??

Sections

7

  • Rear Case
  • 2 steps
  • Battery
  • 1 step
  • Midframe
  • 2 steps
  • Rear Facing Camera
  • 1 step
  • Front Facing Camera
  • 1 step
  • Motherboard
  • 2 steps
  • Headphone Jack
  • 1 step

Flags

1

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackLG G3 Vigor

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear Case
  • Locate the notch on the bottom right of the phone.

Locate the notch on the bottom right of the phone.

1024

Step 2

  • Gently pull the cover on the back of the phone off to locate the battery.

Gently pull the cover on the back of the phone off to locate the battery.

Step 3

              Battery
  • Remove the battery by lifting from the slot at the bottom of the battery.

Remove the battery by lifting from the slot at the bottom of the battery.

Step 4

              Midframe
  • Remove the twelve Phillips #00 screws securing the midframe to the rest of the phone.

Remove the twelve Phillips #00 screws securing the midframe to the rest of the phone.

Step 5

  • Work a plastic opening tool around the perimeter of the phone to separate the midframe from the rest of the phone.

Work a plastic opening tool around the perimeter of the phone to separate the midframe from the rest of the phone.

Step 6

              Rear Facing Camera
  • Use the spudger to gently unplug the ribbon cable connected to the motherboard. Then remove the rear facing camera.

Use the spudger to gently unplug the ribbon cable connected to the motherboard. Then remove the rear facing camera.

Step 7

              Front Facing Camera
  • Use the spudger to gently unplug the ribbon cable connected to the motherboard.
  • Remove the front camera.

Use the spudger to gently unplug the ribbon cable connected to the motherboard.

Remove the front camera.

Step 8

              Motherboard
  • Use the flat edge of a spudger to disconnect the motherboard ribbon connector.

Use the flat edge of a spudger to disconnect the motherboard ribbon connector.

Step 9

  • Use the pointed end of a spudger to push back the two motherboard retaining flaps.
  • The motherboard should now be able to be lifted out of the device.

Use the pointed end of a spudger to push back the two motherboard retaining flaps.

The motherboard should now be able to be lifted out of the device.

Step 10

              Headphone Jack
  • Remove the headphone jack by inserting the spudger into the jack and pulling it up and out.

Remove the headphone jack by inserting the spudger into the jack and pulling it up and out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                    Geoff Wacker

Member since: 09/30/2013

87,546 Reputation

                                      89 Guides authored                  



                       Badges:
                       44







                                                        +41 more badges

flux - Sep 22, 2019

Reply

Works also with D855. There are only a view differences, e.g. screws and a minimal different motherboarddesign.