Difficulty

Moderate

Steps

4

Time Required

Suggest a time??

Sections

2

  • Wristband
  • 2 steps
  • Rear Case
  • 2 steps

Flags

0

  • BackLG G Watch

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Wristband
  • Spring bars attach the two halves of the wristband to the watch body. The spring bar has a shoulder on either end.
  • Be prepared to apply some pressure with your fingers to perform the following action.
  • First, slide the wristband down on the spring bar to expose the shoulder of the spring bar.
  • Grasp the exposed shoulder with the tweezers to perform the next step.

Spring bars attach the two halves of the wristband to the watch body. The spring bar has a shoulder on either end.

Be prepared to apply some pressure with your fingers to perform the following action.

First, slide the wristband down on the spring bar to expose the shoulder of the spring bar.

Grasp the exposed shoulder with the tweezers to perform the next step.

1024

Step 2

  • This is a challenging step. Do it carefully to prevent the spring bar from flying out of the wristband.
  • Use the tweezer to depress the spring bar so that it collapses by a few millimeters and pops out of the hole that was holding it in place.
  • Now carefully pull the other end of the spring bar to detach the wristband from the watch face.
  • Repeat steps 1 and 2 for the other wristband.

This is a challenging step. Do it carefully to prevent the spring bar from flying out of the wristband.

Use the tweezer to depress the spring bar so that it collapses by a few millimeters and pops out of the hole that was holding it in place.

Now carefully pull the other end of the spring bar to detach the wristband from the watch face.

Repeat steps 1 and 2 for the other wristband.

Step 3

              Rear Case
  • Use the T5 Torx screwdriver to unscrew the four silver 2mm x 3mm T5 screws that hold the back cover in place.

Use the T5 Torx screwdriver to unscrew the four silver 2mm x 3mm T5 screws that hold the back cover in place.

Step 4

  • Slide the opening pick between the rear case and the rest of the device to separate the two halves.
  • Gently pull the two halves apart.

Slide the opening pick between the rear case and the rest of the device to separate the two halves.

Gently pull the two halves apart.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                    Geoff Wacker

Member since: 09/30/2013

87,546 Reputation

                                      89 Guides authored                  



                       Badges:
                       44







                                                        +41 more badges