Lg G Watch Gasket Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 minutes

Sections

Wristband
2 steps
Rear Case
2 steps
Gasket
1 step

Flags

BackLG G Watch
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Wristband

Spring bars attach the two halves of the wristband to the watch body. The spring bar has a shoulder on either end.
Be prepared to apply some pressure with your fingers to perform the following action.
First, slide the wristband down on the spring bar to expose the shoulder of the spring bar.
Grasp the exposed shoulder with the tweezers to perform the next step.

Spring bars attach the two halves of the wristband to the watch body. The spring bar has a shoulder on either end.

Be prepared to apply some pressure with your fingers to perform the following action.

First, slide the wristband down on the spring bar to expose the shoulder of the spring bar.

Grasp the exposed shoulder with the tweezers to perform the next step.

1024

Step 2

This is a challenging step. Do it carefully to prevent the spring bar from flying out of the wristband.
Use the tweezer to depress the spring bar so that it collapses by a few millimeters and pops out of the hole that was holding it in place.
Now carefully pull the other end of the spring bar to detach the wristband from the watch face.
Repeat steps 1 and 2 for the other wristband.

This is a challenging step. Do it carefully to prevent the spring bar from flying out of the wristband.

Use the tweezer to depress the spring bar so that it collapses by a few millimeters and pops out of the hole that was holding it in place.

Now carefully pull the other end of the spring bar to detach the wristband from the watch face.

Repeat steps 1 and 2 for the other wristband.

Step 3

              Rear Case

Use the T5 Torx screwdriver to unscrew the four silver 2mm x 3mm T5 screws that hold the back cover in place.

Use the T5 Torx screwdriver to unscrew the four silver 2mm x 3mm T5 screws that hold the back cover in place.

Step 4

Slide the opening pick between the rear case and the rest of the device to separate the two halves.
Gently pull the two halves apart.

Slide the opening pick between the rear case and the rest of the device to separate the two halves.

Gently pull the two halves apart.

Step 5

              Gasket

Use a pair of tweezers to remove the gasket that lies embedded in a groove that runs around the perimeter of the front half.

Use a pair of tweezers to remove the gasket that lies embedded in a groove that runs around the perimeter of the front half.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors

                    Deja Miller

Member since: 10/14/2014

462 Reputation

                                      3 Guides authored                  



                       Badges:
                       20







                                                        +17 more badges

Team

                       USF Tampa, Team 2-5, Blackwell Fall 2014                        

                                                  Member of USF Tampa, Team 2-5, Blackwell Fall 2014 



                    USFT-BLACKWELL-F14S2G5                     


                                            5 Members                     


                                            9 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team