Difficulty
Moderate
Steps
15
Time Required
15 - 20 minutes
Sections
2
- Battery
- 3 steps
- Screen
- 12 steps
Flags
0
BackLG G Vista
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Make sure the device is powered off.
Make sure the device is powered off.
1024
Step 2
- Remove the back cover by gently prying open the case of the device from the charging port.
Remove the back cover by gently prying open the case of the device from the charging port.
Step 3
- Lift the battery out of its place by prying up from the small notch at the base of the battery.
Lift the battery out of its place by prying up from the small notch at the base of the battery.
Step 4
Screen
- Using a Phillips #000 screwdriver, remove all eleven 3.0 mm screws from around the perimeter of the phone.
Using a Phillips #000 screwdriver, remove all eleven 3.0 mm screws from around the perimeter of the phone.
Step 5
- Use a plastic spudger or opening tool and run it along the seam of the upper cover.
- Carefully remove the cover from the device.
Use a plastic spudger or opening tool and run it along the seam of the upper cover.
Carefully remove the cover from the device.
Step 6
- Use the same method to pry off the hard shell covering at the bottom.
Use the same method to pry off the hard shell covering at the bottom.
Step 7
- Remove the two 1 mm Phillips #000 screws.
Remove the two 1 mm Phillips #000 screws.
Step 8
- Gently using tweezers, disconnect the connector that is on the bottom right.
Gently using tweezers, disconnect the connector that is on the bottom right.
Step 9
- Gently unplug the antenna wires on the bottom left and right sides of the device.
Gently unplug the antenna wires on the bottom left and right sides of the device.
Step 10
- With your plastic opening tool, gently lift up the bottom edge of the exposed charging port, sliding along the edge until it lifts out.
With your plastic opening tool, gently lift up the bottom edge of the exposed charging port, sliding along the edge until it lifts out.
Step 11
- Using tweezers, unplug the four connectors.
Using tweezers, unplug the four connectors.
Step 12
- Remove the antenna wires on both sides of the device.
Remove the antenna wires on both sides of the device.
Step 13
- Carefully lift out the back camera from the device.
- Lift out the headphone jack in the upper right side of the device.
Carefully lift out the back camera from the device.
Lift out the headphone jack in the upper right side of the device.
Step 14
- Remove the motherboard from the phone.
Remove the motherboard from the phone.
Step 15
- Remove the vibration motor from the device.
- You will be left with the entire display assembly of the device.
Remove the vibration motor from the device.
You will be left with the entire display assembly of the device.
To reassemble your device, follow these steps in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 3 other contributors
Key Baker
Member since: 01/18/2018
754 Reputation
5 Guides authored
Badges:
9
+6 more badges
Team
Eastern Washington University, Team S2-G1, Munoz Winter 2018
Member of Eastern Washington University, Team S2-G1, Munoz Winter 2018
EWU-MUNOZ-W18S2G1
5 Members
10 Guides authored
