Lg G Pad 7 0 Lte Camera Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 - 15 minutes

Sections

Removing the Back Cover
2 steps
Camera
3 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

BackLG G Pad 7.0 LTE
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

What you need

Step 1

              Removing the Back Cover

Power off your device before beginning the battery replacement (hold the button with the red marker until the device prompts you to power it off, then tap “Power Off”).
Be wary of the front screen and SIM Card while tearing down the device.

Power off your device before beginning the battery replacement (hold the button with the red marker until the device prompts you to power it off, then tap “Power Off”).

Be wary of the front screen and SIM Card while tearing down the device.

1024

Step 2

Put on an Anti-Static Wrist Strap to prevent damage to sensitive electrical components (optional).
To separate the frame from the cover, pry between the screen and the cover using a plastic prying tool.
Begin at the top left of the device to avoid damaging the motherboard and work your way around the perimeter of the screen.
When you pry your device open, be wary of the volume rockers, motherboard, and camera. These components are delicate and can be sensitive to static electricity.

Put on an Anti-Static Wrist Strap to prevent damage to sensitive electrical components (optional).

To separate the frame from the cover, pry between the screen and the cover using a plastic prying tool.

Begin at the top left of the device to avoid damaging the motherboard and work your way around the perimeter of the screen.

When you pry your device open, be wary of the volume rockers, motherboard, and camera. These components are delicate and can be sensitive to static electricity.

Step 3

              Camera

Disconnect camera ribbon cable by prying up on it with a plastic pry tool.

Disconnect camera ribbon cable by prying up on it with a plastic pry tool.

Step 4

There is a light adhesive holding the camera in the device.
Using tweezers or a small plastic pry tool gently pull or pry the camera out of the device (red marker).

There is a light adhesive holding the camera in the device.

Using tweezers or a small plastic pry tool gently pull or pry the camera out of the device (red marker).

Step 5

Install the new camera into device by gently placing it in its corresponding place until it pops in.

Install the new camera into device by gently placing it in its corresponding place until it pops in.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors

                    Fadi Bitar

Member since: 09/26/2016

880 Reputation

                                      6 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       USF Tampa, Team 14-6, Eyestone Fall 2016                        

                                                  Member of USF Tampa, Team 14-6, Eyestone Fall 2016 



                    USFT-EYESTONE-F16S14G6                     


                                            4 Members                     


                                            12 Guides authored

Better Introduction#

What you need#

Team#

Better Introduction

What you need

Team