Difficulty
Moderate
Steps
3
Time Required
10 - 30 minutes
Sections
1
- Camera
- 3 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackLenovo Yoga Tablet 2-830F
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Camera
- Remove the three screws on the back of the device with the Phillips Screwdriver #00 bit.
- Using the blue opening tools or spudger, gently remove the back cover to expose the interior of the tablet.
Remove the three screws on the back of the device with the Phillips Screwdriver #00 bit.
Using the blue opening tools or spudger, gently remove the back cover to expose the interior of the tablet.
1024
Step 2
- Using the Phillips Screwdriver #00 bit remove the 6 screws.
- Using the Phillips Screwdriver #00 bit remove the 3 screws.
- After removing all the screws, disconnect the ribbon cables.
- Disconnect the ZIF connectors.
- Some of the ribbon cables are secured with clips, simply pry up the clips before sliding them out of the pin connectors.
Using the Phillips Screwdriver #00 bit remove the 6 screws.
Using the Phillips Screwdriver #00 bit remove the 3 screws.
After removing all the screws, disconnect the ribbon cables.
Disconnect the ZIF connectors.
Some of the ribbon cables are secured with clips, simply pry up the clips before sliding them out of the pin connectors.
Step 3
- After removing the motherboard and antennas the camera module is located on the right as marked in red.
- Remove the three 2mm screws holding the module in place with the Phillips Screwdriver #00 bit.
- The camera module is also held in place with adhesive so gently remove.
After removing the motherboard and antennas the camera module is located on the right as marked in red.
Remove the three 2mm screws holding the module in place with the Phillips Screwdriver #00 bit.
The camera module is also held in place with adhesive so gently remove.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Mario Gjyli
Member since: 09/28/2017
429 Reputation
3 Guides authored
Badges:
9
+6 more badges
Team
USF Tampa, Team S2-G4, Nance Fall 2017
Member of USF Tampa, Team S2-G4, Nance Fall 2017
USFT-NANCE-F17S2G4
3 Members
12 Guides authored