Difficulty
Moderate
Steps
7
Time Required
15 minutes
Sections
2
- Back Cover
- 3 steps
- Back Camera
- 4 steps
Flags
0
BackLenovo Yoga Tablet 10
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Cover
- Remove the two Phillips #000 screws.
- These screws are located behind the stand for the device.
- Our device did not include these screws.
Remove the two Phillips #000 screws.
These screws are located behind the stand for the device.
Our device did not include these screws.
1024
Step 2
- Use a plastic iFixit opening tool to pry the edges of the back case loose by placing it in between the edge of the cover and the screen.
- Do not immediately attempt to remove the back of the case without attempting Step three, or you risk snapping the back cover.
Use a plastic iFixit opening tool to pry the edges of the back case loose by placing it in between the edge of the cover and the screen.
Do not immediately attempt to remove the back of the case without attempting Step three, or you risk snapping the back cover.
Step 3
- Use the spudger to reach into the center of the device and pry off the back case by giving it a light force upwards.
Use the spudger to reach into the center of the device and pry off the back case by giving it a light force upwards.
Step 4
Back Camera
- Remove one 5mm screw using the Phillips #00 Screwdriver.
Remove one 5mm screw using the Phillips #00 Screwdriver.
Step 5
- Use the spudger to disconnect the camera and battery from the printed circuit board by putting the spudger in between the connections and the printed circuit board and pushing the spudger up.
Use the spudger to disconnect the camera and battery from the printed circuit board by putting the spudger in between the connections and the printed circuit board and pushing the spudger up.
Step 6
- Remove one 5mm screw with the Phillips #00 screwdriver.
Remove one 5mm screw with the Phillips #00 screwdriver.
Step 7
- Use the nylon tip tweezers to push the camera out from between the power button and the kickstand.
Use the nylon tip tweezers to push the camera out from between the power button and the kickstand.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Juan Benjamin
Member since: 01/24/2019
490 Reputation
4 Guides authored
Badges:
11
+8 more badges
Team
Cal Poly, Team S2-G6, White Winter 2019
Member of Cal Poly, Team S2-G6, White Winter 2019
CPSU-WHITE-W19S2G6
4 Members
7 Guides authored
Fixin Ma Stuff - Dec 24, 2019
Reply
“To reassemble your device, follow these instructions in reverse order. “ Including unripping the power switch tail, which is soldered to the board. Look at the last picture!
The camera/speaker assembly cannot be removed without unsoldering this tail.