Lenovo Yoga Tab 3 8 Kickstand Lock Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          7 minutes

Sections

Back Cover
3 steps
Kickstand Lock
2 steps

Flags

BackLenovo Yoga Tab 3 8
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Cover

Open the kickstand by pressing the release button in the center.
Remove the identification sticker with a pair of tweezers to allow access to the two 2mm screws underneath.

Open the kickstand by pressing the release button in the center.

Remove the identification sticker with a pair of tweezers to allow access to the two 2mm screws underneath.

1024

Step 2

Remove the three 2mm screws under the kickstand with a PH00 screwdriver.
The third 2mm screw to the right may have an S sticker covering it which you can scrape off.

Remove the three 2mm screws under the kickstand with a PH00 screwdriver.

The third 2mm screw to the right may have an S sticker covering it which you can scrape off.

Step 3

Starting along the edge opposite of the hinge, insert a plastic opening tool between the screen and the backing to begin separating the small clips holding the backing on.
Work along the edge and then up the sides, separating the clips with the plastic opening tool.
There is adhesive underneath the slot for the SD card so you will need to slowly apply some force to break the adhesive.
As the back is separated from the device, be careful to not lose the power button. It may come loose and fall out.

Starting along the edge opposite of the hinge, insert a plastic opening tool between the screen and the backing to begin separating the small clips holding the backing on.

Work along the edge and then up the sides, separating the clips with the plastic opening tool.

There is adhesive underneath the slot for the SD card so you will need to slowly apply some force to break the adhesive.

As the back is separated from the device, be careful to not lose the power button. It may come loose and fall out.

Step 4

              Kickstand Lock

Locate the four 2mm screws that secure the lock and remove them with a PH00 screwdriver.

Locate the four 2mm screws that secure the lock and remove them with a PH00 screwdriver.

Step 5

Pry the lock up with a metal spudger. There is adhesive holding the mechanism down. Carefully separate it using even pressure.

Pry the lock up with a metal spudger. There is adhesive holding the mechanism down. Carefully separate it using even pressure.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors

                    Nicklaus Krems

Member since: 09/25/2017

1,049 Reputation

                                      8 Guides authored                  



                       Badges:
                       16







                                                        +13 more badges

Team

                       USF Tampa, Team S16-G2, Eyestone Fall 2017                        

                                                  Member of USF Tampa, Team S16-G2, Eyestone Fall 2017 



                    USFT-EYESTONE-F17S16G2                     


                                            4 Members                     


                                            16 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team