Difficulty
Moderate
Steps
8
Time Required
30 - 45 minutes
Sections
1
- Display
- 8 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackLenovo Yoga C930-13IKB
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Display
- Using a halberd spudger, gently lift up the metal bezel that lines the lower edge of the display.
Using a halberd spudger, gently lift up the metal bezel that lines the lower edge of the display.
1024
Step 2
- Remove the ten 3 mm screws along the bottom edge of the display with a Phillips #00 screwdriver.
Remove the ten 3 mm screws along the bottom edge of the display with a Phillips #00 screwdriver.
Step 3
- Gently wedge two opening picks underneath the display.
- Slowly work the opening picks around the display.
- Add opening picks as needed to keep display separated from the frame.
- Use caution if dealing with broken glass.
- The iFixit suction cup tool can be used to add some extra leverage to the mix when removing the display.
Gently wedge two opening picks underneath the display.
Slowly work the opening picks around the display.
Add opening picks as needed to keep display separated from the frame.
Use caution if dealing with broken glass.
The iFixit suction cup tool can be used to add some extra leverage to the mix when removing the display.
Step 4
- Gently flip the display assembly to rest on top of the keyboard.
Gently flip the display assembly to rest on top of the keyboard.
Step 5
- Use the halberd spudger to lift the locking tab of the ZIF connector holding the black ribbon cable that runs vertically across the display.
- Pull out the black ribbon cable from the connector.
Use the halberd spudger to lift the locking tab of the ZIF connector holding the black ribbon cable that runs vertically across the display.
Pull out the black ribbon cable from the connector.
Step 6
- Use the halberd spudger to lift the latch on the ZIF connector of the horizontal black ribbon cable.
- Pull out the horizontal black ribbon cable from the connector.
- Gently pull the rest of the horizontal black ribbon cable from the back of the display.
Use the halberd spudger to lift the latch on the ZIF connector of the horizontal black ribbon cable.
Pull out the horizontal black ribbon cable from the connector.
Gently pull the rest of the horizontal black ribbon cable from the back of the display.
Step 7
- Use the halberd spudger to flip the metal latch of the display cable up.
- Using the halberd spudger, gently pull the connector out of the display.
Use the halberd spudger to flip the metal latch of the display cable up.
Using the halberd spudger, gently pull the connector out of the display.
Step 8
- Gently lift the display away from the laptop frame.
Gently lift the display away from the laptop frame.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Josiah Grayson Sawyer
Member since: 09/17/2020
481 Reputation
3 Guides authored
Badges:
6
+3 more badges
Team
The Citadel Military College of South Carolina, Team S3-G23, Eggleston Fall 2020
Member of The Citadel Military College of South Carolina, Team S3-G23, Eggleston Fall 2020
CMCSC-EGGLESTON-F20S3G23
3 Members
3 Guides authored
Roberto Meniketti - Sep 3, 2022
Reply
The screen is glued with iphone battery tape so you have to pull the white tabs at the bottom of the screen to release the tape as like almost all the last generation screens.
