Difficulty
Moderate
Steps
6
Time Required
15 - 30 minutes
Sections
3
- Back Panel
- 1 step
- Battery
- 2 steps
- Wi-Fi Card
- 3 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackLenovo Yoga 910-13IKB
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Turn the laptop over and remove the ten Torx T5 screws along the perimeter of the bottom panel using the T5 Torx Screwdriver.
- Remove the back panel from the device exposing the components.
Turn the laptop over and remove the ten Torx T5 screws along the perimeter of the bottom panel using the T5 Torx Screwdriver.
Remove the back panel from the device exposing the components.
1024
Step 2
Battery
- Remove the four 3 mm Phillips #0 screws holding the battery in place.
Remove the four 3 mm Phillips #0 screws holding the battery in place.
Step 3
- Disconnect the battery cable from its motherboard socket by gently pulling it towards the battery. The spudger tool may be needed to lift the flap seal.
- Pull parallel to the battery, not straight up.
- Pull evenly on the width of the cable so that no individual wire is overly strained.
- Lift the battery out.
Disconnect the battery cable from its motherboard socket by gently pulling it towards the battery. The spudger tool may be needed to lift the flap seal.
Pull parallel to the battery, not straight up.
Pull evenly on the width of the cable so that no individual wire is overly strained.
Lift the battery out.
Step 4
Wi-Fi Card
- Remove the single 1 mm screw at left of Wi-Fi card with a Phillips #0 screwdriver.
Remove the single 1 mm screw at left of Wi-Fi card with a Phillips #0 screwdriver.
Step 5
- Pull the Wi-Fi card out of the slot on the motherboard.
- It is still connected to the coaxial cables so don’t yank it out or those connections will break.
Pull the Wi-Fi card out of the slot on the motherboard.
It is still connected to the coaxial cables so don’t yank it out or those connections will break.
Step 6
- Detach the white wire that is connected to the Wi-Fi card by applying gentle pressure.
- Detach the black wire by applying gentle pressure.
Detach the white wire that is connected to the Wi-Fi card by applying gentle pressure.
Detach the black wire by applying gentle pressure.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Tyler Jane McClure
Member since: 01/18/2022
117 Reputation
1 Guide authored
Badges:
7
+4 more badges
Team
Embry-Riddle Aeronautical University, Team 2-5, Rauch Spring 2022
Member of Embry-Riddle Aeronautical University, Team 2-5, Rauch Spring 2022
ERAU-RAUCH-S22S2G5
3 Members
2 Guides authored