Difficulty
Moderate
Steps
8
Time Required
20 minutes
Sections
3
- Back Cover
- 2 steps
- Battery
- 2 steps
- Trackpad
- 4 steps
Flags
0
BackLenovo Yoga 900-13ISK
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Be sure to unplug and completely turn off your device before you start working.
What you need
Step 1
Back Cover
- Using a T5 Torx screwdriver, remove the ten 5.5 mm screws from the back case of the laptop.
Using a T5 Torx screwdriver, remove the ten 5.5 mm screws from the back case of the laptop.
1024
Step 2
- Use a spudger to pry open the back case at the hinges of the laptop.
- There are plastic clips around the perimeter of the case holding down the back cover. These will need to be popped off as the cover is removed.
- Use your fingers to completely pop off the back cover.
Use a spudger to pry open the back case at the hinges of the laptop.
There are plastic clips around the perimeter of the case holding down the back cover. These will need to be popped off as the cover is removed.
Use your fingers to completely pop off the back cover.
Step 3
Battery
- Remove the five 3.6 mm screws from the battery with a Phillips #00 screwdriver.
Remove the five 3.6 mm screws from the battery with a Phillips #00 screwdriver.
Step 4
- Grab the bottom corners of the battery and gently pull the battery until the cable disconnects from the connector on the motherboard.
- While reassembling, use a plastic spudger to push the battery cable into the connector on the underside of the motherboard. This will be easier to do before the screws are replaced.
Grab the bottom corners of the battery and gently pull the battery until the cable disconnects from the connector on the motherboard.
While reassembling, use a plastic spudger to push the battery cable into the connector on the underside of the motherboard. This will be easier to do before the screws are replaced.
Step 5
Trackpad
- Use a spudger to lift the hinged black tab of the ZIF connector on the trackpad.
Use a spudger to lift the hinged black tab of the ZIF connector on the trackpad.
Step 6
- Pull the cable out from the connector with your fingers.
Pull the cable out from the connector with your fingers.
Step 7
- Remove the six 2.2 mm screws from the trackpad with a Phillips #00 screwdriver.
Remove the six 2.2 mm screws from the trackpad with a Phillips #00 screwdriver.
Step 8
- Press the trackpad up from the bottom by opening the laptop slightly and applying pressure from the keyboard side.
- Remove the trackpad.
Press the trackpad up from the bottom by opening the laptop slightly and applying pressure from the keyboard side.
Remove the trackpad.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
Austin Blakely
Member since: 03/11/2019
16,291 Reputation
52 Guides authored
Badges:
37
+34 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,772 Guides authored