Lenovo Yoga 730 15Ikb Right Fan Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          15 - 30 minutes            

Sections

2

• Bottom Cover
• 3 steps
• Right Fan
• 3 steps

Flags

0

• BackLenovo YOGA 730-15IKB

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

If your fans are noisy or create a high-pitched whining noise, they may need to be replaced. You can also try blowing compressed air into the fan to remove any built-up dust that may be slowing it down.

What you need

Step 1

              Bottom Cover               

• Turn off the computer and unplug the charger before going any further.
• Flip the laptop over so you can see the underside.
• Remove the ten 7mm T5 Torx screws.

Turn off the computer and unplug the charger before going any further.

Flip the laptop over so you can see the underside.

Remove the ten 7mm T5 Torx screws.

1024

Step 2

• Pry up the bottom cover with an opening tool.
• Start at the front edge of the cover and make your way along the sides.

Pry up the bottom cover with an opening tool.

Start at the front edge of the cover and make your way along the sides.

Step 3

• Pull the bottom cover up and away from the back hinges.

Pull the bottom cover up and away from the back hinges.

Step 4

              Right Fan               

• When the laptop is upside down, the right fan is on the left side of the laptop near the large metal RAM cover.
• Disconnect the fan cable. Pull the wire toward the back of the laptop while wiggling to loosen the connection.
• You can also use the white tabs on the connector to push the cable free.

When the laptop is upside down, the right fan is on the left side of the laptop near the large metal RAM cover.

Disconnect the fan cable. Pull the wire toward the back of the laptop while wiggling to loosen the connection.

You can also use the white tabs on the connector to push the cable free.

Step 5

• Remove two 4mm Phillips #1 screws.

Remove two 4mm Phillips #1 screws.

Step 6

• Pull the fan up and towards the front of the laptop.

Pull the fan up and towards the front of the laptop.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Daniel Rodriguez Salinas                     

Member since: 01/23/2020

433 Reputation

                                      4 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       Cal Poly, Team S1-G6, White Winter 2020                        

                                                  Member of Cal Poly, Team S1-G6, White Winter 2020 



                    CPSU-WHITE-W20S1G6                     


                                            3 Members                     


                                            27 Guides authored