Difficulty
Moderate
Steps
5
Time Required
7 - 10 minutes
Sections
2
- Bottom Cover
- 2 steps
- Wireless Adapter
- 3 steps
Flags
0
BackLenovo Yoga 720-15IKB
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
To complete this repair you’ll need a Torx T5 and a Phillips #0 screwdriver.
What you need
Step 1
Bottom Cover
- Power off the device before starting.
- Flip the device over with the hinges facing away from you.
- Remove seven 5.0 mm Torx T5 screws.
- Remove three 9.5 mm Torx T5 screws.
Power off the device before starting.
Flip the device over with the hinges facing away from you.
Remove seven 5.0 mm Torx T5 screws.
Remove three 9.5 mm Torx T5 screws.
1024
Step 2
- Pry around the edges from one side to another with a plastic opening tool.
- Do not pry on the side with the hinges because this can break the cover.
- Lift the case from the front until you feel resistance.
- Do not keep lifting after you feel resistance, or the bottom cover can break.
- Pull the cover towards you, away from the hinges.
- Completely lift off the cover.
Pry around the edges from one side to another with a plastic opening tool.
Do not pry on the side with the hinges because this can break the cover.
Lift the case from the front until you feel resistance.
Do not keep lifting after you feel resistance, or the bottom cover can break.
Pull the cover towards you, away from the hinges.
Completely lift off the cover.
Step 3
Wireless Adapter
- Lift the foam covering the connecting wires and screw, and use the Phillips #0 screwdriver to remove the 2mm screw.
Lift the foam covering the connecting wires and screw, and use the Phillips #0 screwdriver to remove the 2mm screw.
Step 4
- Grab the adapter from both sides and pull towards the hinge to remove the adapter from the device.
Grab the adapter from both sides and pull towards the hinge to remove the adapter from the device.
Step 5
- Remove the black and white wires from the adapter by pulling up on each wire.
- When reassembling, make sure to press each wire connector firmly onto the new adapter to make sure it is a secure fit.
Remove the black and white wires from the adapter by pulling up on each wire.
When reassembling, make sure to press each wire connector firmly onto the new adapter to make sure it is a secure fit.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Matthew Bornhorst
Member since: 01/23/2020
405 Reputation
2 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team S19-G3, White Winter 2020
Member of Cal Poly, Team S19-G3, White Winter 2020
CPSU-WHITE-W20S19G3
4 Members
22 Guides authored