Difficulty

Easy

Steps

6

Time Required

                          15 - 20 minutes

Sections

2

  • Battery
  • 4 steps
  • Trackpad
  • 2 steps

Flags

3

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackLenovo Yoga 710-11ISK

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Flip the device having the bottom panel facing you.
  • Remove the eleven 5mm Torx T5 screws from the back panel.

Flip the device having the bottom panel facing you.

Remove the eleven 5mm Torx T5 screws from the back panel.

1024

Step 2

              Removing back cover
  • Remove the back panel carefully.
  • To remove the back cover, there are 5 plastic snap hooks that must be dislodged with a spudger or plastic pick tool.
  • Lay the device upside down with hinges away from you. Tilt it at 45 degree angle, leaving hinges down and open the screen slightly. Apply a little pressure on one corner to see where it separates. Then work from side to side to separate the back case from the top case. The back case is a shell with no components in it.

Remove the back panel carefully.

To remove the back cover, there are 5 plastic snap hooks that must be dislodged with a spudger or plastic pick tool.

Lay the device upside down with hinges away from you. Tilt it at 45 degree angle, leaving hinges down and open the screen slightly. Apply a little pressure on one corner to see where it separates. Then work from side to side to separate the back case from the top case. The back case is a shell with no components in it.

Step 3

  • Remove the two 3mm Phillips #1 screws that are holding the battery to the device.
  • Hold the bundled cable connector on each side and carefully pull the connector to release it from the motherboard.

Remove the two 3mm Phillips #1 screws that are holding the battery to the device.

Hold the bundled cable connector on each side and carefully pull the connector to release it from the motherboard.

Step 4

  • Remove the battery carefully from the device by lifting up the edge nearest you and then gently pull toward you to disconnect the power wires.

Remove the battery carefully from the device by lifting up the edge nearest you and then gently pull toward you to disconnect the power wires.

Step 5

              Trackpad
  • Using a Phillips #00 screwdriver, remove the three 3mm screws located at the top of the trackpad.

Using a Phillips #00 screwdriver, remove the three 3mm screws located at the top of the trackpad.

Step 6

  • Remove the trackpad from the device.

Remove the trackpad from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Richard

Member since: 02/18/2021

241 Reputation

                                      3 Guides authored                  



                       Badges:
                       3

Team

                       The Citadel Military College of South Carolina, Team S2-G19, Eggleston Spring 2021                        

                                                  Member of The Citadel Military College of South Carolina, Team S2-G19, Eggleston Spring 2021 



                    CMCSC-EGGLESTON-S21S2G19                     


                                            3 Members                     


                                            3 Guides authored