Difficulty

Moderate

Steps

5

Time Required

                          30 - 50 minutes

Sections

1

  • Speaker
  • 5 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackLenovo Yoga 710-11ISK

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Speaker
  • Remove the 11 screws located on the back panel using a T5 Torx screwdriver.

Remove the 11 screws located on the back panel using a T5 Torx screwdriver.

1024

Step 2

  • Insert an opening tool between the bottom panel and chassis, then pry around the entire perimeter until the five clips detach, releasing the bottom panel.

Insert an opening tool between the bottom panel and chassis, then pry around the entire perimeter until the five clips detach, releasing the bottom panel.

Step 3

  • Use a Phillips #000 screwdriver to remove the four screws securing the battery.
  • Grip the battery cable connector on both sides of the plug and gently pull it directly from its port.
  • Lift the battery up and out.

Use a Phillips #000 screwdriver to remove the four screws securing the battery.

Grip the battery cable connector on both sides of the plug and gently pull it directly from its port.

Lift the battery up and out.

Step 4

  • Unplug the wire harness on the left side of the computer to disconnect the speakers from the motherboard
  • Remove the white and blue wires from the plastic brackets holding them in place.

Unplug the wire harness on the left side of the computer to disconnect the speakers from the motherboard

Remove the white and blue wires from the plastic brackets holding them in place.

Step 5

  • Carefully remove both speakers and rubber grommets from their mounts.
  • Slide the right speaker underneath the white ribbon wire.
  • Lift the speakers up and out.

Carefully remove both speakers and rubber grommets from their mounts.

Slide the right speaker underneath the white ribbon wire.

Lift the speakers up and out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Jarrett Stoll

Member since: 02/10/2022

385 Reputation

                                      3 Guides authored                  



                       Badges:
                       3

Team

                       The Citadel Military College of South Carolina, Team 1-6, Eggleston Spring 2022                        

                                                  Member of The Citadel Military College of South Carolina, Team 1-6, Eggleston Spring 2022 



                    CMCSC-EGGLESTON-S22S1G6                     


                                            3 Members                     


                                            3 Guides authored