Lenovo Yoga 710 11Isk Hinge Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          35 minutes - 1 hour

Sections

Hinge
7 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

BackLenovo Yoga 710-11ISK
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Hinge

Remove the eleven screws that secure the bottom panel using a T5 Torx screwdriver.

Remove the eleven screws that secure the bottom panel using a T5 Torx screwdriver.

1024

Step 2

Insert an opening tool between the bottom panel and chassis, then pry around the entire perimeter until the five clips detach, releasing the bottom panel.

Insert an opening tool between the bottom panel and chassis, then pry around the entire perimeter until the five clips detach, releasing the bottom panel.

Step 3

Use a Phillips #000 screwdriver to remove the ten black screws on the two hinge brackets.

Use a Phillips #000 screwdriver to remove the ten black screws on the two hinge brackets.

Step 4

Wedge an opening tool between the display and display housing, then slide the opening tool around the perimeter of the display while gently prying until the display releases.
Remove the screw covers located near the hinges on the display side using an opening tool.
Remove the cover panel between the screw covers using an opening tool.

Wedge an opening tool between the display and display housing, then slide the opening tool around the perimeter of the display while gently prying until the display releases.

Remove the screw covers located near the hinges on the display side using an opening tool.

Remove the cover panel between the screw covers using an opening tool.

Step 5

Remove the screws securing the hinge brackets with a Phillips #000 screwdriver.
Remove the plastic cover that holds the wires in place.

Remove the screws securing the hinge brackets with a Phillips #000 screwdriver.

Remove the plastic cover that holds the wires in place.

Step 6

Disconnect the black and white wires from the sides of the display.
Disconnect the orange ribbon cable.
Remove the tape, covers, and stickers that hold in the components.

Disconnect the black and white wires from the sides of the display.

Disconnect the orange ribbon cable.

Remove the tape, covers, and stickers that hold in the components.

Step 7

Soldering/desoldering presents potential for device damage and burns. Always solder/desolder in a well-ventilated environment.
Use a soldering iron to disconnect the ends of both wires that are embedded into the display.
Remove the hinges and their components from the computer.

Soldering/desoldering presents potential for device damage and burns. Always solder/desolder in a well-ventilated environment.

Use a soldering iron to disconnect the ends of both wires that are embedded into the display.

Remove the hinges and their components from the computer.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor

                    Jarrett Stoll

Member since: 02/10/2022

385 Reputation

                                      3 Guides authored                  



                       Badges:
                       3

Team

                       The Citadel Military College of South Carolina, Team 1-6, Eggleston Spring 2022                        

                                                  Member of The Citadel Military College of South Carolina, Team 1-6, Eggleston Spring 2022 



                    CMCSC-EGGLESTON-S22S1G6                     


                                            3 Members                     


                                            3 Guides authored

Better Introduction#

Introduction#

What you need#

Team#

Better Introduction

Introduction

What you need

Team