Lenovo Yoga 700 11Isk Solid State Drive Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 minutes

Sections

Back Panel
2 steps
Battery
2 steps
Solid State Drive
2 steps

Flags

BackLenovo Yoga 700-11ISK
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Panel

Flip your device so that the bottom panel is facing up.
Remove the eleven 5mm Torx T5 screws from the back panel.

Flip your device so that the bottom panel is facing up.

Remove the eleven 5mm Torx T5 screws from the back panel.

1024

Step 2

Use a spudger to unclip clips on the front and near the USB ports on each side
Lift the back panel off

Use a spudger to unclip clips on the front and near the USB ports on each side

Lift the back panel off

Step 3

              Battery

Remove the two 3mm Phillips #1 screws holding the battery to the laptop chassis.
Disconnect the battery from the IO board by holding the connector by the sides and gently pulling the connector out.

Remove the two 3mm Phillips #1 screws holding the battery to the laptop chassis.

Disconnect the battery from the IO board by holding the connector by the sides and gently pulling the connector out.

Step 4

Carefully remove the battery from the laptop.
Make sure that all wires still connected to the laptop are out of the way and not pulled out with the battery.

Carefully remove the battery from the laptop.

Make sure that all wires still connected to the laptop are out of the way and not pulled out with the battery.

Step 5

              Solid State Drive

Remove the one 2mm Phillips #1 screw holding the hard drive to the laptop.

Remove the one 2mm Phillips #1 screw holding the hard drive to the laptop.

Step 6

Pull the solid state disk out of the connector and lift it out of the laptop.
Make sure the hard drive is oriented correctly with the label facing up before re-inserting.

Pull the solid state disk out of the connector and lift it out of the laptop.

Make sure the hard drive is oriented correctly with the label facing up before re-inserting.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      8 other people completed this guide.

Author

                                      with 4 other contributors

                    Emma Morley

Member since: 10/23/2016

378 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 15-6, Livingston Fall 2016                        

                                                  Member of Cal Poly, Team 15-6, Livingston Fall 2016 



                    CPSU-LIVINGSTON-F16S15G6                     


                                            4 Members                     


                                            7 Guides authored

Bernardino Santiago - Oct 24, 2018

How to transfer the windows os to the newly install Crucial ssd?

how to transfer the windows OS to the newly install ssd?

Joe Rhio - Dec 13, 2019

Specification for the M.2 SSD: Make sure it’s a Type 2280 (22mm x 80mm) SATA M.2 with B and M key edge connector, not the B key used on NvMe M.2 for PCIe. It’s easy to confuse the two when ordering online.

Introduction#

What you need#

Team#

Introduction

What you need

Team