Difficulty
Moderate
Steps
9
Time Required
15 - 30 minutes
Sections
3
- Lower Case
- 6 steps
- Battery Disconnect
- 1 step
- Battery
- 2 steps
Flags
0
BackLenovo Yoga 6 13ALC6
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
For your safety, discharge the battery below 25% before disassembling your device. This reduces the risk of fire if the battery is accidentally damaged during the repair. If your battery is swollen, take appropriate precautions.
What you need
Step 1
Unfasten the lower case
- Use a T5 Torx screwdriver to remove the six 7.2 mm screws securing the lower case.
Use a T5 Torx screwdriver to remove the six 7.2 mm screws securing the lower case.
1024
Step 2
Insert the opening pick
- Insert an opening pick between the lower case and the chassis at a hinge corner.
- Pry up with the pick to release the clips securing the lower case.
- Repeat the process on the other hinge corner.
Insert an opening pick between the lower case and the chassis at a hinge corner.
Pry up with the pick to release the clips securing the lower case.
Repeat the process on the other hinge corner.
Step 3
Release the clips
- Slide the pick along the right edge to release the clips securing the lower case.
Slide the pick along the right edge to release the clips securing the lower case.
Step 4
Release the remaining clips
- Continue sliding the opening pick along the front and left edges to release the remaining clips.
Continue sliding the opening pick along the front and left edges to release the remaining clips.
Step 5
- Insert the pick on the hinge edge and slide along the entire edge to release all of the clips.
Insert the pick on the hinge edge and slide along the entire edge to release all of the clips.
Step 6
- Lift the lower case from the chassis and remove it.
- During reassembly, this is a good point to power on your laptop and test all functions before sealing it up. Be sure to power your laptop back down before you continue working.
Lift the lower case from the chassis and remove it.
During reassembly, this is a good point to power on your laptop and test all functions before sealing it up. Be sure to power your laptop back down before you continue working.
Step 7
Disconnect the battery
- Use the pointed end of a spudger to push each side of the battery connector until it comes out of the socket.
Use the pointed end of a spudger to push each side of the battery connector until it comes out of the socket.
Step 8
Unfasten the battery
- Use a Phillips screwdriver to remove the five 4.2 mm-long screws securing the battery.
Use a Phillips screwdriver to remove the five 4.2 mm-long screws securing the battery.
Step 9
Remove the battery
- Lift the battery straight out of its recess and remove it.
Lift the battery straight out of its recess and remove it.
To reassemble your device, follow these instructions in reverse order.
For optimal performance, calibrate your newly installed battery after completing this guide.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.
Cancel: I did not complete this guide.
Author
Alex Diaz-Kokaisl
Member since: 01/16/2022
58,262 Reputation
300 Guides authored
Badges:
30
+27 more badges
Team
iFixit
Member of iFixit
Community
141 Members
15,772 Guides authored
