Difficulty
Moderate
Steps
11
Time Required
10 minutes
Sections
2
- Battery
- 6 steps
- Speakers
- 5 steps
Flags
0
BackLenovo Yoga 3 Pro
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Before opening your laptop, make sure it is powered off.
- Remove the ten 3.3 mm screws from the base cover using a T5 Torx screwdriver.
Before opening your laptop, make sure it is powered off.
Remove the ten 3.3 mm screws from the base cover using a T5 Torx screwdriver.
1024
Step 2
- Slide the plastic opening tool between the base cover and the frame to pry open the computer.
- Slowly go around the entire perimeter of the computer until all edges are loose.
- Make sure the plastic opening tool doesn’t go too far into the device.
Slide the plastic opening tool between the base cover and the frame to pry open the computer.
Slowly go around the entire perimeter of the computer until all edges are loose.
Make sure the plastic opening tool doesn’t go too far into the device.
Step 3
- Remove the panel and place it in a safe location.
Remove the panel and place it in a safe location.
Step 4
- Remove the six 3.5 mm screws surrounding the battery using a Phillips 00 screwdriver.
Remove the six 3.5 mm screws surrounding the battery using a Phillips 00 screwdriver.
Step 5
- Using either tweezers or your fingers, disconnect the black battery cable by pinching either side of the connector and pulling towards the battery.
Using either tweezers or your fingers, disconnect the black battery cable by pinching either side of the connector and pulling towards the battery.
Step 6
- Carefully lift and remove the battery.
Carefully lift and remove the battery.
Step 7
Speakers
- Remove the four 4 mm screws using the Phillips 00 screwdriver.
Remove the four 4 mm screws using the Phillips 00 screwdriver.
Step 8
- Using the plastic opening tool, flip open tab as shown.
Using the plastic opening tool, flip open tab as shown.
Step 9
- Remove the adhesive tape.
- Flip open the ribbon connecting tab.
- Carefully lift the ribbon connector from its adhesive.
Remove the adhesive tape.
Flip open the ribbon connecting tab.
Carefully lift the ribbon connector from its adhesive.
Step 10
- Remove the speaker and set it on the side.
- Use the plastic opening tool to remove the cables.
- Be careful of other cables.
Remove the speaker and set it on the side.
Use the plastic opening tool to remove the cables.
Be careful of other cables.
Step 11
- Removing the other speaker by unwinding cables.
- Lift both speakers carefully.
Removing the other speaker by unwinding cables.
Lift both speakers carefully.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 5 other contributors
Caroline Seifert
Member since: 10/01/2015
529 Reputation
2 Guides authored
Badges:
15
+12 more badges
Team
Cal Poly, Team 12-17, Maness Fall 2015
Member of Cal Poly, Team 12-17, Maness Fall 2015
CPSU-MANESS-F15S12G17
4 Members
15 Guides authored