Difficulty
Easy
Steps
5
Time Required
20 minutes
Sections
1
- Upgrading/Replacing RAM
- 5 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackLenovo Y700-14ISK
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
battery and upgrading/replacing the RAM.
What you need
Step 1
Remove the back Panel
- Unscrew and take out 10, 1/5 cm screws.
- Unscrew and take out 1, 1 inch screw.
- I use a piece of tape sticky side up to place screws on, also I label it where they go.
Unscrew and take out 10, 1/5 cm screws.
Unscrew and take out 1, 1 inch screw.
I use a piece of tape sticky side up to place screws on, also I label it where they go.
1024
Step 2
Pry up back panel
- With the vents facing away from your body I find it easiest to start at the bottom right corner first and gently pry up the corner using a plastic tool.
- Then slide and pry the plastic tool to the left corner.
- Then work on the sides.
With the vents facing away from your body I find it easiest to start at the bottom right corner first and gently pry up the corner using a plastic tool.
Then slide and pry the plastic tool to the left corner.
Then work on the sides.
Step 3
Pulling off the back panel
- Carefully lift up on the back panel.
- The back will snap out of place but be careful and don’t force it to hard.
Carefully lift up on the back panel.
The back will snap out of place but be careful and don’t force it to hard.
Step 4
Disconnect the battery
- Pull the battery cable out of it’s connector. Gripping the wires in the middle gently wiggling the wires back and forth while pulling.
- With the battery connector out.
Pull the battery cable out of it’s connector. Gripping the wires in the middle gently wiggling the wires back and forth while pulling.
With the battery connector out.
Step 5
Removing the RAM
- Note the tabs on each side of the RAM holder,
- With your fingers or the plastic tool gently move the tabs away from the RAM, the RAM should pop up when both sides or moved.
- Grip the RAM by the sides and lift out.
Note the tabs on each side of the RAM holder,
With your fingers or the plastic tool gently move the tabs away from the RAM, the RAM should pop up when both sides or moved.
Grip the RAM by the sides and lift out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
with 1 other contributor
Corbin Schon
Member since: 01/26/2016
593 Reputation
2 Guides authored
Badges:
9
+6 more badges
cacalo219 - Oct 20, 2018
Reply
Thank you for the guide! It helped me to feel sure about the disassemble.